Troubleshooting - Worx Landroid S Basic Manual Del Propietário

Blue light on
Blue light flashing
twice per cycle
Blue light flashing
three times per
18
cycle
NOTES
• Before turning power on, always return Landroid
message is also displayed when Landroid
• If for any reason—i.e. a party, children playing...—you want to park your Landroid
®
. Landroid
If you want to re-start it, press
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire. Please
refer to the previous installation instructions and check your set up with its help.
• If your lawn is divided in two separate areas connected by a corridor less than 1m, one of which is not provided with
the Charging Base: when Landroid
the main switch (8) to "I"(on), press
®
• If Landroid runs abnormally once in a while, please try to restart it. If the problem is not resolved, try to removing and
reinstalling the battery. If the problem is still not resolved, please contact a WORX.
• Do not wash the machine with a high pressure washer. This could cause damage to the battery or the machine.

11. Troubleshooting

®
If your Landroid does not work correctly, follow the troubleshooting guide below. If the issue persists, contact your Dealer.
Symptom
®
Landroid turns on, but the Blade
Disc does not move.
Owner's Manual of Lawn Mowing Robot EN
Wheel motor blocked
Blade disc blocked
®
Landroid is lifted up.
®
Landroid is upside
down.
®
will go to its charging base and stay there. Landroid
and
®
runs out of charge, take it manually to the Charging Base, turn power on by turning
and
®
Landroid is searching for the Charging
Base (unless you press the HOME
button to make it go to the charging
base, or the "Enable boundary cut"
function is operating).
®
1. Turn Landroid off; take Landroid
®
2. Turn Landroid on. Wait until the battery indication light stays green. (If
®
Landroid has low battery capacity, the battery indication light will stay
red.) Press .
3. If the error message is still displayed; turn power off; turn Landroid
upside-down and check if there's anything preventing the wheels from
rotating.
4. Remove any obstruction, turn Landroid
®
1. Turn Landroid off;
®
2. Turn Landroid upside down and check if there's anything preventing
the blade disc to rotate.
3. Remove any obstruction.
®
4. Turn Landroid upright and take it to an area with short grass or adjust
the cutting height;
®
5. Turn Landroid on. Wait until the battery indication light stays green. (If
®
Landroid has low battery capacity, the battery indication light will stay
red.) Press .
®
1. Turn Landroid off.
®
2. Take Landroid to a lawn area clear of obstacles, turn Landroid
Wait until the battery indication light stays green. (If Landroid
battery capacity, the battery indication light will stay red.) Press
3. If the error message is still displayed: turn Landroid
upside-down and check there's nothing lifted up.
4. Remove any possible object, turn Landroid
®
1. Turn Landroid off.
®
2. Turn Landroid upright.
®
3. Turn Landroid on. Wait until the battery indication light stays green. (If
®
Landroid has low battery capacity, the battery indication light will stay
red.) Press .
®
to its territory. If not, the error indication light will flash red. This
is sitting over the boundary wire when turned on.
®
will wait until the next scheduled mowing session.
to start mowing.
, the charge process will start.
Cause
®
to an area free of obstacles;
®
upright, turn power on.
®
off, turn Landroid
®
upright, turn Landroid
®
in the Charging Base: press
Action
®
This is normal. Landroid needs to recharge,
the Blade Disc does not rotate while it is
searching for the Charging Base automatically.
®
®
on.
®
has low
.
®
®
on.
and