Worx Landroid S Basic Manual Del Propietário página 19

®
Landroid vibrates.
Grass is being cut unevenly.
®
Your Landroid is inside its
territory and the boundary wire
is connected. The error indication
light flashes red.
The charging time is far more
than 2h.
The mower does not charge.
®
Landroid is starting to have
shorter run-times between
charges.
®
Landroid is not operating at the
correct time.
®
Landroid cannot correctly dock
with the Charging Base
The Green light on the Charging
Base turns ON before charging is
complete.
Owner's Manual of Lawn Mowing Robot EN
Blades may be damaged. Check
condition of the Blade Disc.
®
Landroid does not work enough hours
per day.
Mowing area is too big.
Blades are dull.
The cutting height is too low for the
length of the grass.
Grass or other object has wrapped
around the blade disc.
There is a build-up of grass in the Blade
Disc or Motor Frame Box.
The boundary wire ends are clamped
incorrectly.
Poor connection caused by debris on
the Charging Strip.
The charging protection program has
activated due to high temperature.
There is no power.
Does not operate correctly while
manually charging.
Something is clogging in the Blade
Disc.
®
Landroid is shaking heavily.
The battery may be exhausted or old.
The clock is not set to the correct time.
Programmed cutting times for
®
Landroid are not correct.
Environmental influences
Poor connection caused by debris on
the Charging Strip.
The charging base is overheating, the
battery indication light flashes red.
Check the Blades, and replace them if
damaged.
Remove debris and foreign objects from the
blades and blade disc.
Add more hours to the scheduled mowing
time.
Try decreasing the size of the mowing area or
adding more hours to the mowing time.
Change all the Blades and screws in order to
balance the Bade Disc.
Raise the cutting height and then gradually
lower.
Check the Blade Disc and remove the grass
or other object.
Make sure the Blade Disc rotates easily. If
need be, you may take off the Blade Disc and
remove the debris.
Reverse the boundary wire ends.
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Refer to manual charging.
Take off the Blade Disc and clean it
The grass is too high and too thick.
Check the Blade Disc and blades, remove
debris and foreign objects from the blades
and Blade Disc.
Replace battery.
Set the clock to the correct time by removing
and installing the battery pack.
Change the time settings for the mower to
start and stop.
®
Restart Landroid .
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
19