Starting Up; Replacing The Power Cable - EINHELL RT-RH 26 Manual De Instrucciones

Anleitung_RT_RH_26_SPK7__ 19.05.14 08:23 Seite 15
6.3. Tool insertion (Fig. 4)
Clean the tool before insertion and apply a thin
n
coating of drill bit grease to the shaft of the tool.
Pull back and hold the locking sleeve (2).
n
Insert the dust-free tool into the tool mounting as
n
far as it will go whilst turning it. The tool will lock
itself.
Check that it is properly secure by pulling the
n
tool.
6.4. Tool removal (Fig. 5)
Pull back and hold the locking sleeve (2) and remove
the tool.

7. Starting up

Important.
To prevent all danger, the machine must only be
held using the two handles (5 / 6). Otherwise there
may be a risk of suffering an electric shock if you drill
into cables.
7.1 ON/OFF switch (Fig. 6/Item 4)
First fit a suitable drill bit into the tool (see 6.3).
n
Connect the mains plug to a suitable socket.
n
Position the drill in the position you wish to drill.
n
To switch on:
Press the ON/OFF switch (4)
To switch off:
Release the ON/OFF switch (4).
7.2 Clockwise/Counter-clockwise switch
(Fig. 6/Item 9)
Change switch position only when the drill is
n
at a standstill!
Switch the direction of the hammer drill using the
n
clockwise/counter-clockwise switch (9):
Direction
Clockwise (forwards and drill) Pushed in to the right
Counter-clockwise (reverse)
7.3 Drill / Hammer drill / Chisel selector switch
(Fig. 7)
For drilling, press the button (E) on the rotary
n
switch (3) and simultaneously turn the rotary
switch (3) to position A.
For hammer drilling, press the button (E) on the
n
rotary switch (3) and simultaneously turn the
rotary switch (3) to position B.
For chiseling, press the button (E) on the rotary
n
switch (3) and simultaneously turn the rotary
switch (3) to position C. In switch position C the
chisel is not locked.
For chiseling, press the button (E) on the rotary
n
switch (3) and simultaneously turn the rotary
switch (3) to position D. The chisel is locked in
position D.
Important.
Only low pressure is required for hammer drilling.
Excessive pressure will exert an unnecessary force
on the motor. Check the drill bits at regular intervals.
Sharpen or replace blunt drill bits.
7.4 Press control (Fig. 8/Item 8)
To ensure the ideal contact pressure, the edge of the
housing (a) must be located in the middle section of
the indicator (8).
The indicator serves only as a guidance and
should not be observed permanently.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
Switch position
Pushed in to the left
GB
15