Adjusting The Playback-Speed - Omnitronic DMS-1050 Manual Del Usuario

6.6 Adjusting the playback-speed

Possibility 1:
Via the Pitchfader, you can adjust the playback-speed by up to +/-100 %.
Put the CD-player into playback-mode. Press the Pitch Control-button in order to activate the Pitchfader
(LED on).
Select the speed-adjustment range by pressing the 4/8/16/100%-button.
Adjust the playback-speed via the Pitchfader (Pitch-LED of the respective speed is on).
Possibility 2:
Via the Pitch Bend-buttons you can adjust the playback-speed temporarily.
Put the CD-player into playback-mode. Press the desired Pitch Bend-button. After letting the Pitch Bend-
button loose, the player automatically returns to the original playback-speed.
Motor Off-effect:
The Motor Off-effect equals the slow stopping of the turntable, if the motor is switched off. This effect is
activated via the Pitch Bend - button. If you hold the Pitch Bend - button, the playback-speeds decreases
down to 0. If the CD has "stopped", you can re-activate playback by releasing the Pitch Bend - button.
Possibility 3:
In the playback-mode, you can adjust the playback-speed by +/- 100 % via the Scratch-wheel.
6.7 Cueing
Auto-Cue function:
After switching on and after pressing the Track-buttons, the player automatically jumps to the section where
the music starts. This function enable to minimize the transitions between two tracks.
If the Auto Cue-function is disabled, a time interval remains between two tracks until the music starts. If the
Auto Cue-function is activated (the display shows "Auto Cue"), the music starts immediately.
Back-Cue function:
If you press the Cue-button during playback, the player returns to the track-start or Cue-point (In-button) and
goes into Pause-mode. Please note that this function is only available within one track.
Memorizing the Cue-point:
Possibility 1:
The player is in Playback-mode.
Press the In-button and the Cue-point is memorized. The Cue-indicator shortly flashes.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the Cue-point via the Scratch-wheel. The display shows the selected starting-point (e.g. 3:42 22).
Press the In-button and the Cue-point is memorized. The Cue-indicator shortly flashes.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
Possibility 3:
The player is in Pause-mode or in Playback-mode.
Press the Track-button to select the desired track. The Cue-indicator shortly flashes and the Cue-point is set
to the track-start.
Memorizing several Cue-points:
With the DMS-1050, you can memorize up to 4 different Cue-points of different tracks and recall them via the
Bank-button or the Cue-button, respectively.
Hold the Sampler/Memory -button and press the desired Bank-button in order to memorize the current Cue-
point on the Bank-button.
By pressing the respective Bank-button, you can recall the Cue-points memorized via the Sampler/Memory-
button. The last memorized Cue-point can be recalled by pressing the Cue-button.
The memorized Cue-points can be overritten at any time. Please note that the Cue-points can only be
deleted by switching the CD-player off an on again.
26/56 10602425_V_1_0