Cleaning And Maintenance; Replacing The Crossfader - Omnitronic DSS-2 Manual Del Usuario

SYMPTOMS
Device does not react when swit-
ching on.
Player does not start operation
No sound
Does not read the program
Pop noise

8. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device will be damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

Replacing the Crossfader

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.
POSSIBLE CAUSES
Connection to mains disrupted.
CD is badly positioned or dirty
Check the mixer and amplifier
connections
The player is in normal playback
mode
Mixer or amplifier connections
inapropriate
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
SOLUTION
Check
connection.
Reposition CD with label atop or
clean with a dry and soft cloth.
Possibly exchange connections.
Press the Play/Pause-button and
re-program
Check cable and jack quality
32/64
AC plug and AC
10553155_V_1_0.DOC