Delta 36-714B Manual De Instrucciones página 13

HOW TO ATTACH A SAW BLADE
Disconnect the machine from the power source!
1. Raise the saw blade arbor to its maximum height.
Attach the saw blade (C) Fig. 25 to the saw arbor with
the teeth of the blade pointing down toward the front of
the table (Fig. 25). Attach the flange (D) and arbor nut
(E) to the saw arbor. Tighten the arbor nut (E) by hand
with the saw blade against the inner blade flange.
2. Place the open end wrench (F) Fig. 25 on the flats of the
saw arbor and tighten the arbor nut (E) with the other
wrench (G). Turn the arbor nut clockwise.
HOW TO ALIGN THE SPLITTER WITH THE BLADE
Disconnect the machine from the power source!
Use a straight edge to check the alignment of the saw blade
(B) with the rear of the splitter (G) in Fig. 26. To align, loosen
the screws (A) Fig. 27 that hold the splitter bracket to the
rear trunnion. Align the splitter (G) Fig. 26 with the saw blade
and tighten two bolts (A) Fig. 27.
HOW TO INSTALL THE TABLE INSERT
Disconnect the machine from the power source!
Lower the saw blade and install the table insert (P) Fig. 28
in the saw table.
IMPORTANT: When installing the table insert, hold the
blade guard (L). After insertion, the insert will automatically
release the holding action of the splitter and lower the blade
guard.
Secure the insert with the M5 x 20mm screw in the hole
(M).
M
13
G
F
E
D
C
Fig. 25
G
B
Fig. 26
A
Fig. 27
L
P
Fig. 28