Maytag MED5591TQ1 Manual De Uso página 11

When connecting totheterminal block, p lace t hehooked end ofthewireunder the screw of
theterminal block ( hook f acing right), squeeze hooked end together and tighten s crew, as
shown,
1,
2.
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and place the hooked end (hook facing right) of the neutral wire (white or
center wire) of direct wire cable under the center screw of the terminal block. Squeeze
hooked ends together. Tighten screw.
A B
......... C
A. Fxte'rnal ground conductor screw - Dotted line shows
position of NEUTRAL ground wire' before being moved to
center silver-colored terminal block screw.
B. COnter silver-colored terminal block screw
C. Neutral wire (white or center wire)
D. _4" ( 1.9 cm) Ut listed strain relief
E. Neutral ground wire
5,
6.
Connect ground wire/green or bare) of power supply cable to external ground conductor
screw. Tighten screw.
C
A. Lxternal ground conductor screw
B. Center silver-colored terminal block screw
C. Neutral wire' (white' or center wire)
D. Y_" (1.9 cm) UL li_ted strain relief
E. Ground wire" (green or bare) of power supply cable"
f. Neutral ground wire
Place the hooked ends of the other power supply cable wires under the outer terminal
block screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
!! !!
ram--
lighten strain relief screws.
Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
(JOWl]
screw.
You have completed your electrical connections. Now go to "Venting Requirements."