Maytag MED5591TQ1 Manual De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

As Needed
Cleaning
1.
Roll lint off the screen with your fingers.
2.
Wet both sides of lint screen with
hot water.
3.
Wet a nylon brush with hot water and liquid
detergent.
Scrub lint screen with the brush to
remove
residue buildup.
4.
Rinse screen with
hot water.
5.
Thoroughly
dry lint screen with
a clean towel.
Replace screen in dryer.
1.
Apply
a liquid,
nonflammable
household
cleaner to the stained
area of the drum and rub
with a soft cloth until stain is removed.
2.
Wipe
drum thoroughly
with
a damp cloth.
3.
Tumble
a load of clean cloths or towels
to dry the drum.
NOTE: Garments
that contain
unstable
dyes, such as denim
blue jeans or [)rightly
colored
cotton
items, may discolor
the dryer interior.
These stains are not harmful
to your dryer and
will
not stain future loads of clothes.
Dry unstable
dye items inside-out
to avoid transfer of
dye.
From
Inside
the Dryer
Cabinet
lint should
be removed
every 2 years, or more often, depending
on dryer usage. Cleaning
should
be clone by a qualific'd
person.
From the
Exhaust
Vent
lint should
be removed
every 2 years, or more often, depending
on dryer usage.
Vacation
care
Operate
your dryer only when you are at home.
If you will be on vacation
or not using your
dryer for an extended
period
of time, you should:
1.
Unplug
dryer or disconnect
power.
2.
Clean lint screen. See "Cleaning
the I.int Screen."
Moving
care
For power
supply
cord-connected
dryers:
1.
Unplug
the power supply
cord.
2.
Make sure leveling
legs are secure in dryer base.
3.
Use masking
tape to secure dryer door.
For direct-wired
dryers:
Electrical
Shock
Hazard
Disconnect
power
before
servicing.
Replace
all parts and panels
before
operating.
Failure
to do so can result
in death
or electrical
shock.
1.
Disconnect
power.
2.
Disconnect
wiring.
3.
Make sure leveling
legs are secure in dryer base.
4.
Use masking tape to secure dryer door.
1.
Unplug
dryer or disconnect
power.
2.
Open the dryer door. locate
the light bulb cover on the back wall of the dryer. Remove
the screw
located
in the lower right-hand
corner of the cover. Remove
the cover.
3.
[urn
bulb counterclockwise.
Replace the bulb with a 10-watt
appliance
bull) only.
Replace the cover and secure with the screw.
4.
Plug in dryer or reconnect
power.

Publicidad

Tabla de contenido
loading

Tabla de contenido