Descargar Imprimir esta página

Leviton 476TM-652 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

CAT 5e Twist & Mount (476TM-524):
Consists of:
• 24 Ports of Category 5e
• Route telephone, fax, modem, Ethernet to 24 locations
CAT 6 Twist & Mount (476TM-624):
Consists of:
• 24 Ports of Category 6
• Route telephone, fax, modem, Gigabit Ethernet to 24 locations
Package Contents
The following items are included with your Panel:
• Twist & Mount Patch Panel preloaded with CAT5e and/or CAT6
boards
• Plastic 110 Termination Tool
• Four Push-Lock Pins and Grommets
• Wiring ID Labels
Required Tools
For wire termination the following tools are required:
• Angle cutters (if using the provided Plastic 110 Termination Tool)
• Professional Impact Tool with 110 Cutting Blade
• Wire Cutters
• UTP Wire Stripping Tool
1) GETTING STARTED
Planning
Plan your cable routing carefully to determine which distribution panel will satisfy your
requirements. Determine the number of outlet locations required for phone, fax, modem,
and Ethernet and/or Gigabit Ethernet service.
Define
Label each wire with its corresponding location or ID number. Use the provided Wiring
Identification Chart at the end of these instructions to map the placement of your wires in
the Panel, and for reference when filling out the wiring ID labels for the front of the Twist &
Mount Panel. The numbers on the termination side of the Twist & Mount correspond with
the jack position on the front of the Panel.
Organize
In the SMC, separate the voice wires from the data wires for ease of termination. Determine
how you will route your wires into the Panel for termination. You can bring your wires in
through the top or bottom of the Panel feeding the wires into the wire channels which will
hold them in place during termination and when twisting the panel for mounting. Generally
if conduit is used you will want to come in through the bottom of the panel to provide an
adequate service loop.
2) INSTALLATION
Twist & Mount Patch Panel
During cable termination the Twist & Mount Panel must be mounted with the 110 IDCs
facing out of the enclosure. Make sure the top of the panel is facing the top of the SMC.
Align the installation hooks with the grid holes on the back of the enclosure and slide the
Panel down so it hangs securely in the enclosure.
3
CAT 5e
CAT 5e
CAT 6
CAT 6

Publicidad

loading

Este manual también es adecuado para:

476tm-512476tm-612476tm-654476tm-524476tm-624