Turning direction:
check operation using the mini-pushbuttons
CERRAR (close) and ABRIR (open). If the turning
direction is not correct, interchange the operator
cables connected in cable connectors 13 and 14.
10
General connections
(ST1)
(start)
(ST2)
(DIP9=OFF: FCC)
(DIP9=ON: FCA)
ST1
COM
ST2
Limit switches configuration (DIP9)
DIP9=ON
SW2 Functions during programming (DIP1=ON)
DIP1=ON: programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON: total open/close programming
DIP1=ON and DIP3=ON: pedestrian open/close programming
DIP1=ON and DIP4=ON: total opening radio code programming
DIP1=ON and DIP6=ON: pedestrian opening radio code programming
(pedestrian)
FC1
Encoder (DIP7):
for the correct operation of the encoder, ensure
DIP7 is in ON.
FC2
(DIP9=OFF: FCA
(DIP9=ON: FCC)
DIP9=OFF
(close)
(open)