MrHeater MH530FAET Instrucciones De Funcionamiento Y Manual Del Propietario página 19

NE JAMAIS LAISSER LE CHAUFF NE JAMAIS LAISSER LE CHAUFF NE JAMAIS LAISSER LE
SPÉCIFICATIONS
Modèle : MH530FAET
Puissance­de­chauffage­ 18084/5300
BTU/Watts
Débit­d'air­(pi /min) 246
3
Alimentation­électrique 240Vac
Thermostat 32°F­-­185°F
Cordon­d'alimentation 4'­POWER­CABLE­INCLUDED 4'­POWER­CABLE­INCLUDED
Dimensions:­(L"xW"xH") 13.18"x12.2"x13.97" 14.37"x13.77"x16.14"
Poidst­(lbs.) 16.7­LBS.
Dégagement des produits combustibles
Sortie­(M) 6'­(1.8M)
Arrière­(M) 2'­(.6M)
Côtés­(M) 2'­(.6M)
Assembly Installation:
&
•­ Remove­the­heater­and­all­of­the­packaging­material­from­
the­box.
•­ Check­all­of­the­packing­material­for­loose­parts­and­set­
aside.
•­ Thoroughly­inspect­the­heater­for­damage.­If­any­is­found­
do­not­contact­the­place­of­purchase.­Please­call­the­
Manufacturer­at­800-251-0001.
INCLUDED­IN­THE­BOX:
•­ Heater
•­ Hanging­bracket
•­ Mounting­plate
•­ Swivel­Plate
•­ Angle­adjustment­knobs
•­ Heater­fastening­bolts
•­ 4-­8­mm­Nuts,­Bolts­and­lock­washers
To­Assemble,­use­the­8­mm­nuts,­bolts­and­lock­washers­to­the­
attach­the­swivel­plate­and­the­Mounting­Plate­to­the­hanging­
bracket­See­figure­1.­The­nut­and­lock­washer­should­be­on­the­
underside.
Next,­Locate­a­space­to­hang­the­heater­on­the­ceiling.­The­
Figure­1.
selected­space­should­leave­enough­room­to­maintain­the­
Mr. Heater Forced-Air Electric Construction Heater
CHAUFFAGE SANS SUR AGE SANS AGE SANS SUR SURVEILLANCE PENDANT LE BRÛLAGE!
MH530FAERT
18084/5300
246
240Vac
32°F­-­185°F
17.75­LBS.
6'­(1.8M)
2'­(.6M)
2'­(.6M)
3
VEILLANCE PENDANT LE BRÛLAGE! VEILLANCE PENDANT LE BRÛLAGE!
clearance­to­combustibles­outlined­in­the­specifications­table­
on­page­3­and­should­be­located­within­4­feet­of­your­power­
connection­or­the­location­of­where­you­plan­to­mount­the­
junction­box­your­heater­will­be­supplied­from.­
Once­a­location­has­been­selected,­fasten­the­mounting­bracket­
and­accompanying­hanging­kit­with­4­appropriately­sized­lag­
bolts/or­wall­anchors­that­can­support­the­weight­of­the­heater­
(not­included).­The­weight­of­your­heater­can­be­found­in­the­
specifications­table­on­page­3.­The­best­option­is­to­attach­the­
anchors­directly­into­a­solid­surface­like­a­joist­or­plywood.­If­
that­is­not­available­consult­with­your­local­hardware­store­for­
other­options.­There­are­many­different­Drywall­anchors­or­
masonry­anchors­that­will­work.­­
Once­you­have­selected­a­location­and­mounted­the­hanging­
brackets­you­can­now­hang­the­heater.­It­is­recommend­that­
you­have­help­for­this­step.­While­you­or­your­helper­is­holding­
the­heater­in­place,­Install­the­two­large­Phillips­head­bolts­and­
angle­adjustment­knobs.­See­figure­2.­At­this­point­the­heater­
should­look­like­the­photo­on­the­front­of­this­manual.­
Figure­2.
FRONT­OF­HEATER
Wiring information:
The­heaters­covered­in­this­manual­are­designed­to­be­installed­and­
serviced­by­only­licensed­trained­professionals.­­Heaters­should­only­
be­installed­on­a­dedicated­240­volt­circuit­with­a­30­amp­double­
pole­breaker.­Refer­to­NEC­code
Remote Thermostat:
Units­equipped­with­a­remote­thermostat­will­need­to­have­the­
cradle­for­the­thermostat­mounted­in­an­appropriate­location.­
Using­two­wall­anchors,­(not­included)­mount­the­Thermostat­
cradle­to­the­wall.­Select­a­location­within­3.5­feet­of­the­
heater.­The­cradle­should­be­mounted­in­a­location­as­to­not­be­
affected­by­the­air­flow­of­the­heater.­If­possible­do­not­mount­
on­an­un-insulated­wall­or­in­direct­sunlight.­That­may­cause­the­
heater­to­cycle­unnecessarily.­
Operational Information
Operating Instructions and Owner's Manual
XXXXXXXXXX for­specifics.­