Delta BS150LS Manual De Instrucciones página 16

ADJUSTING THE TABLE
POSiTiVE STOPS
Positive stops are provided for the table at the 90 and
45 degree angle to the blade. To check and adjust the
positive stops:
Disconnect machine from power
source.
1.
2.
Tilt the table to the 90 degree position as shown in
Fig. 32 and tighten lock handle (A). Place a square
(H) on the table and against the blade and check to
see if the blade is 90 degrees to the table surface. If
an adjustment is necessary:
Tilt the table to expose the lock nut (E) Fig. 33.
Loosen lock nut (E) and return table to the 90 °
position. With the lock handle (A) Fig. 32 loose, turn
the adjusting screw (F) Fig. 34, using the 3mm hex
wrench provided until the blade is 90 degrees to the
table. Then tighten lock handle (A) and lock nut (E) on
the adjustment screw (F).
Fig. 32
3.
Tilt the table to the 45 degree position as shown
in Fig. 34. Place a square (H) Fig. 34 on the table
and against the blade and check to see if the blade
is 45 degrees to the table surface. If an adjustment
is necessary.
.
Loosen the lock nut (N) Fig. 33 on the adjustment
screw (J) located on the underside of the table. With
the lock handle (A) Fig. 34 loose, turn adjustment
screw (J) using 3mm hex wrench provided until
the blade is 45 degrees to the table. Tighten lock
handle (A) and lock nut (N) on the adjustment screw
(d).
16
Fig. 33
Fig. 34