IKRA BAS 3020 Instrucciones De Manejo página 50

Step 5:
Use the included wrench to tighten the nut turning it an-
ticlockwise.
Secure the screw with the spilt pin again.
Make sure to unblock the gear again by removingthe Al-
len Key from the bore on the side of retaining flange.
Mounting the trimmer
Step:
Mount the protection shield extension as shown in figure
using the 3 included screws nuts and washers.
When operating the device in connection with the ny-
lon line cutting head, the plastic protection cover must
always be installed to cut the nylon cutting line to the
correct length and to protect the operator.
Remove the split pin from the end of the drive shaft
Insert an Allen Key into the hole on the side of the lower
retaining flange to prevent the gear from turning. Use the
included wrench to unscrew the nut turning it clockwise.
Remove the upper retaining flange.
Make sure to keep the nut, split pin and upper retaining
flange. These parts will be required to mount the metal
blade!
Screw the cutting head onto the thread by turning it anti-
clockwise and fasten it hand-tight.
Please make sure that the line spool is properly seated
in the spool housing, the spring is located under the line
spool, and the line ends are led to the outside through-
both eyelets.
Replacing the cutting cord
Remove the screw by turning it clockwise.
Remove the coil and spring from the spindle.
Remove the remaining cutting cord.
GB-21