SPARKY M 2000 HD Instrucciones De Uso página 11

the initial and any following operation.
sponds to the value indicated on the name
plate with technical data of the tool.
The power tool must be connected and dis-
connected to the power supply socket only
is connected to a receptacle while the power
switch is in the ON position, the power tool
will start operating immediately, which could
cause a serious accident.
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
tion that the direction-of-rotation arrow on the
diamond cutting disc and the direction of rota-
tion of the machine (see direction-of-rotation
arrow on the machine head) agree.
on the name plate. The peripheral speed in-
dicated on the wheel must not be less than
80 m/s. The wheels must be stored according
the recommendations of the manufacturer.
er source, use as short as practicable exten-
sion cord with proper cross-section.
mounted and reliably tightened.
SWITCHING ON - SWITCHING OFF
The angle grinder is secured against uninten-
tional switching on.
button 8 positioned at the bottom of the main
continuous operation switch 7 can be locked
(only for models with index P in the abbre-
viation). In this case while holding switch 7,
press button 8 and then release switch 7.
that switch.
Original instructions
In case of mains drop-out (or temporary
drop-out for time t > 0.5 s), when the ON/
-
OFF switch is in ON position, the machine
should not operate after supply recovering.
off and then switch on the lever of ON/OFF
switch 7.
WHEEL GUARD
WARNING: The wheel guard 3.1 for
grinding wheel or the wheel guard 3.2 for
cutting wheel (for grinding wheel 2.1 or cut-
ting wheel 2.2 accordingly) must always be
mounted on the machine!
WARNING: Before performing the fol-
lowing operations, switch off and unplug the
machine.
Mounting the wheel guard (Fig. 1)
-
that the crevice S of the ring coincides with the
- Place the wheel guard in non-operating
cide with the four grooves in the bearing seat
lease it.
- Press the wheel guard down and rotate it
- - Release the fastening lever L to a stable
grooves).
Rotating the wheel guard in a new operat¬ing
position
lease it.
- Rotate the wheel guard to the necessary
operating position.
- Release the fastening lever L to a stable
grooves).
Removing the wheel guard
lease it.
- Rotate the wheel guard in non-operating
cide with the four grooves in the bearing seat
-
-
-
-
-
9
EN