Maintenance - SPARKY M 2000 HD Instrucciones De Uso

- Remove the wheel guard.
GRINDING WHEEL REPLACEMENT
WARNING: Before performing the fol-
lowing operations, switch off and unplug the
machine.
Secure spindle 1 by pressing the spindle lock
button 9 on the gear case.
WARNING: Never press button 9
while the spindle is still rotating!
in direction opposite to the arrow marked on
the wheel guard 3 until it has profoundly gone
wrench. Place the new wheel on the sup-
wrench. Use blotters if the wheel has been
delivered with them. If the wheel thickness is
the wheel opening. After replacing the wheel,
operate the machine with the new wheel in
no load mode for one minute. Vibrating or
otherwise improperly rotating wheels must be
replaced immediately and discarded.
spindle 1 by means of an open-end wrench.
to accept the spindle thread.
plastic (rubber) backing pad 11, under which
fasten it with the lock nut 13, delivered with
directly onto the spindle by a wrench without
with hook-and-loop fastening to the sandpa-
per. After replacing the wheel, operate the
machine with the new backing pad in no load
mode for one minute. Vibrating or otherwise
10
EN
improperly rotating backing pads must be re-
placed immediately and discarded.
AUXILIARY HANDLE (Fig.5)
Normally auxiliary handle 6 is screwed on the
machine left side. It can be screwed also on
the machine right side or top if this is more
convenient for the operator. The machines are
equipped with a third threaded socket for cou-
pling the auxiliary handle. The auxiliary handle
for these models is connected to the body of the
machine through vibration dampers, protecting
the operator and reducing fatigue.
TURNING THE MACHINE CASE
The machine case can be turned to 90
way of mounting is implemented when the ma-
chine is used mainly for cutting-off operations.
In this case turning the machine case must be
carried out in an authorized service centre for
SPARKY power tools.
RECOMMENDATIONS
When cutting, do not apply pressure, do not os-
cillate the wheel. Work with moderate feed rate,
suited to the material to be machined.
machine must always be fed against the direc-
tion of wheel rotation. Otherwise, danger exists
for the wheel to be forced uncontrolled out of the
best to start with the smallest cross section.
When grinding do not apply pressure to the
processed surface by rearing down on the ma-
chine but move the wheel regularly backwards
and forwards. Special wheels shall be used for
processing non-ferrous metals. Best results
when roughing can be achieved with the wheel
0 0
inclined at 30 to 40 to the processed surface
Never use cutting wheels for roughing opera-
tions. Usage of wheels thicker than 10 mm is
not recommended.

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
0 . This