Controls - Wetrok Speedmatic Tornado Instrucciones De Manejo

Controls

FIG 3
Electric sweeper
6
Petrol sweeper
Descriptions of controls (fig. 3)
1) Suction shut-off and filter shaking lever
Pull back this lever to shut off suction on wet floors. Pull the lever all the
way back to activate the filter shaker motor.
A: Suction ON
C: Suction shut OFF
V: Filter shaker on
2) Main brush lifting/lowering lever
– Pull this lever up, to raise the main brush for sweeper transfer purposes
or when you finish work.
– Push the lever down to lower the main brush to start sweeping.
– The lever features an adjuster to regulate the height to which the brush
is lowered and compensate for brush wear (see chapter "Main brush" –
adjusting the main brush).
A: Brush DOWN
S: Brush UP
3) Starter key-switch
The position for the starter key-switch is:
0: Engine stopped, key can be removed.
1: Electric system energised.
2: Starter motor engaged.
!
CAUTION! never leave the key in the position 1 when the
engine is not running.
(electric sweeper)
The position for the starter key-switch is:
0: Engine stopped, key can be removed.
1: Electric system energised.
4) Choke (petrol sweeper)
Facilitates starting from cold, particularly in cold weather. Use the choke
always when starting a cold engine.
Position A: Choke off.
Position B: Choke on.
5) Vacuum fan/Brushes motor switch
Operate this switch to switch on the suction fan and main and side brush
motor.
2
8
6) Side brush lifting/lowering lever
– Move this lever to position A to lift the side brush(es) for sweeper trans-
fer purposes or when you finish work.
– Move the lever to position B to lower the side brush(es) to start
sweeping.
A. Brushes DOWN
S. Brushes UP
7) Drive pedal
(petrol sweeper)
Direction A: FORWARD
Direction R: BACK (reverse)
(electric sweeper)
Push on the switch 8 (fig. 3) to select the direction of the sweeper. Act on
pedal 7 for the transfer.
8) Forward/reverse drive switch
(electric sweeper)
The switch 8 selects the direction of the sweeper FORWARD OR REVERSE.
Direction I: FORWARD
Direction II: BACK (reverse)
Act on pedal 7 for the transfer.
9 -11) Service brake pedal and parking brake handle
The pedal and lock ball grip operate the service brake and parking brake
respectively. Press down on pedal 9 to apply the brake block to the rear
wheels. Apply the lock handle 11 to hold the brake on to park the machine
For brake adjustment see chapter "Service and parking brakes".
10) Flap lifting pedal
Press this pedal down to lift the front flap in order to pass it over rubbish.
Which would otherwise be pushed in front of the machine.
12) Battery charge indicator
(electric sweeper)
This indicator lights 12 show the current condition of charge of the batte-
ries. The colour of the indicator changes from green to yellow to red as the
level of battery charge diminishes.
GREEN LIGHT: batteries fully charged
YELLOW LIGHT: batteries partly charged
RED LIGHT: batteries discharged
13) Horn Button
Press on button 13 to operate the horn.
25