Philips RQ1200 Serie Manual De Instrucciones página 17

3 Simultaneously press the release buttons on both sides of the
cleaning chamber (1). Then lift the Jet Clean System off the cleaning
chamber (2).
The cleaning chamber remains behind.
,
4 Unscrew the cap from the bottle with HQ200 cleaning fluid.
5 Fill the cleaning chamber with HQ200 cleaning fluid to a level
between the two lines.
6 Place the Jet Clean System back onto the cleaning chamber.
Make sure the release buttons click back into place.
Using the Jet Clean System
Note: If you use the shaver with shaving foam or shaving gel, we advise you
to rinse it under the hot tap before you clean it in the Jet Clean System. This
guarantees an optimal lifetime for the cleaning fluid.
1 Hold the shaver upside down above the holder with the back of the
shaver pointing towards the holder.
2 Place the shaver body in the holder behind the two clips (1) and
press it down until it locks into place (2).
The display shows that the shaver is charging (see chapter 'The
,
display').
3 RQ1008: Press the up/down button to select a cleaning program.
ENGLISH
17 17