Clatronic BS 1256 Instrucciones De Servicio página 40

Ill. 1
Ill. 2
Ill. 3
Ill. 4
40
05-BS 1256 40
Emptying the Dust Container
• Turn the device off and
remove the mains plug from
the socket. Pull the handle
of the vacuum cleaner and
remove the dust container.
• Press the button on the side
of the container to empty its
contents.
• Then close the fl ap of the
dust container again.
• Reinsert the dust container,
ensuring that it clearly clicks
into place.
1. Motor Protective Filter (in the
Dust Container)
Cleaning the Filter Element
Important:
Always empty the dust con-
tainer fi rst before removing
the fi lter element.
• Remove the dust container
(see illustration 1).
• Remove the contents of
the dust container. In order
to do this, press the button
on the dust container (see
illustration 2).
• Turn the lid (see illustration 3)
in the direction „ " and then
lift it off, including the fi lter
element.
• Turn the fi lter element in the
„OPEN" direction to remove
it from the lid. Remove the
fi lter element (two parts)
and clean the main fi lter by
tapping out the contents and
gently brushing.
• Now replace the compon-
ents. Please then turn the
fi lter element in the CLOSE
direction until it is tight.
• Place the lid on the dust
container - the arrow is
located above the „ " symbol
- and then turn it in the „ "
direction until it is tight.
•
• Now place this back in position once it has completely dried!
Caution: Never wash the fi lter in the washing machine,
and please do not use a hairdryer to dry it.
2. Inlet fi lter
•
Ill. 5
• Please ensure that the fi lter is always clean, as otherwise
air circulation cannot be guaranteed. If necessary, the fi lter
can also be washed in warm water without any additives.
Place it back into place only once it is completely dry!
3. Outlet fi lter
•
•
•
Ill. 6
•
• Then pull the grille out towards the front. Remove the fi lter
and clean as described above. Fit the fi lter back into place
and close the ventilation grid by following the steps above in
the opposite order.
Important note!
• Cleaning may become necessary after a shorter time,
depending on the conditions of use, e.g. when vacuuming
fi ne dust.
• If the suction power of your vacuum cleaner diminishes
please clean the fi lters as described.
• If the suction power suddenly diminishes during operation
this may be due to the fi lters being locked.
Every third time the dust con-
tainer is emptied, or in the
case of severe soiling, clean
the fi lter by allowing water to
fl ow through the fi lter fabric
against the direction in which
the vacuum cleaner blows.
The dust container should
only be reinserted when it is
completely dry!
The inlet fi lter is located
below the dust container
compartment. Remove the
dust container and then the
inlet fi lter. Clean the inlet fi lter
approximately every tenth
time the dust container is
emptied, or more frequently if
necessary.
The appliance is also equip-
ped with an outlet fi lter.
In order to ensure that the
fi lter works correctly, we
recommend that you replace
it every six months.
It is located on the rear part
of your appliance behind a
ventilation grid.
Open the ventilation grille by
pressing the lever on its side.
04.05.2007, 11:48:32 Uhr