Using The Appliance; Switching Off - Clatronic BS 1256 Instrucciones De Servicio

WARNING:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
Never throw batteries into the fi re.

Using the Appliance

1. Fit on the accessory.
2. Unwind the required length of cable and insert the mains
plug into a correctly installed 230 V, 50 Hz power socket.
Turn the device on by the on/off switch. The power-on lamp
lights up.
3. Remote control: Turn the device on beforehand with the
on/off switch (the power-on lamp lights up). With the remote
control on the handle you can turn the device on and off.
With the +/- buttons the suction power is increased or
reduced.
4. Vacuum at a steady speed. There is no need to exert
pressure.
NOTE:
Pay attention to the range that can be covered with the cable
length.
Vacuum power regulator (+/- button)
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device
• Pull out the cable up to the maximum length indicated with
the yellow mark.
• Never pull the cable out up to the red mark as the cable
winding can be damaged. Said damages are not covered by
the warranty.
Winding
Press the cable winding button and guide the cable. Hold the
cable to avoid wrapping.
Telescope Vacuum Pipe
The height-adjustable vacuum pipe enables individual alignment
to your height.
• Unlock the coupling by pressing the key in the direction of
the arrow.
• Slide the vacuum pipe to the desired length. To lock the
device, release the key until you hear it lock in place.

Switching off

• Turn the device to standby with the „ " button on the remote
control (the power-on lamp lights up).
• Turn the device off with the on/off switch. The control lamp
goes off. Then remove the mains plug from the socket.
05-BS 1256 39
For curtains and delicate fabrics.
For long-pile velour carpets and
textile fl ooring.
For sturdy rugs and fl oors.
Nozzle accessories
NOTE:
The accessories are to be found in the holder on the tele-
scopic tube.
Groove and
brush nozzle: For vacuuming upholstery, curtains and
in corners and crevices etc.
„2-in-1" nozzle: When this is folded toge-
ther it can be used as a groove nozzle.
If you would like to use the brush nozzle,
pull the brush section in the direction of
the arrow until it locks in place.
Upholstery nozzle: For cleaning upholstery, curtains etc.
Metal fl oor nozzle: To clean carpets or smooth surfaces.
Smooth fl oors:
Press down the lever with the brush
symbol with your foot. The brush is now
visible.
Carpets:
Press down the opposite lever.
Parquet brush: The fl oor nozzle is fi tted with rollers for
improved manoeuvrability. For large
areas such as parquet, laminate or tiles
etc.
Turbo brush: The fl oor nozzle is fi tted with rollers for
improved manoeuvrability. The brush is
equipped with a rotating and swivelling
brush roller driven by the air current.
Removes ground-in dirt, animal hairs,
threads and fl uff particularly thoroughly.
The carpet pile is brushed up to look
almost new.
Please note that the turbo brush is
not suitable for smooth fl oors, e.g.
parquet, laminate etc. as the surface
might be damaged.
Releasing the nozzles: Pull these off while turning slightly.
Filling Level Indicator of the Dust Container
Hold the suction tube loosely in the air. If the fi lling level indicator
(19) lights up the container is full. Empty the container as
described below and reinsert it.
Filter
Your machine has three fi lter systems. The traditional dust bag
system has been replaced by a transparent dust container. In
this, coarse dirt particles and tiny particles fl oating in the air are
swirled out of the suction air by the high speed of the air current.
The purchase of dust bags is no longer necessary.
Once the dust level has reached the MAX mark on the dust con-
tainer, or the suction power of the vacuum cleaner is reduced,
please proceed as follows:
39
04.05.2007, 11:48:29 Uhr