MyWay Q-Fix2.3 Instrucciones De Uso página 14

Idiomas disponibles

In the event of an emergency

In case of an emergency your child can be released quickly by pressing the red button

on the buckle of the car safety belt.

If your child seat has been involved in an accident, you MUST dispose of it and pur-

chase a new one. Even if your child seat shows no signs of damage, there may be

weakness that you are unable to see. If this child seat is involved in another accident

it may fail to protect your child.

For this reason we suggest that you never use or purchase a second hand car seat.

Checking the vehicle seat belt

WARNING: only use the MyWay Q-Fix child seat in the forward facing position. Your child

seat must only be installed forward facing using a three point seatbelt with retractor, in the

front or rear passenger seats of the vehicle

Fig. 1

Q-Fix 2-3 can be installed on vehicle seats equipped with Isoﬁ x anchor points, but ALWAYS

in combination with the car seat belt. To check the correct compatibility, see the Vehicle Ap-

plication list.

Checking the vehicle seat belt buckle

The position of the seat belt buckle can affect the stability of the child safety seat. In an ac-

cident this could stop the car seat from protecting your child as well as it should. If the buckle

lies across the seat as shown in the picture, this child safety seat is not suitable for use with

this seat belt or vehicle.

Fig. 2

Fitting the child seat -15 to 25 kg. (Universal Category)

Install the child seat on the appropriate vehicle seat. Make sure the vehicle seat is upright

and in its most rearward position. Place the child into the car seat and fasten the seat belt.

Make sure that both sections of the seat belt guide pass through the armrest next to the seat

belt buckle.

Check that the seat belt has not become twisted and tighten by pulling the diagonal strap

upwards.

Fig. 3

Adjusting the backrest height

Make sure that the diagonal vehicle seat belt section passes over the child's shoulder, but

does not touch his/her neck.

Fig. 5

To reach the right belt position, you can easily adjust the backrest height by following these

operations:

To raise the backrest: grip the top of the backrest and pull upwards until the diagonal car

seat belt section is in the positioned right on the top of the shoulder.

libretto qfix4.indd 14

05/02/2010 15.09.04