Johnson Pump SPX FLOW Serie Manual De Instrucciones página 8

> English
Threaded Discharge Installa-
tion Instructions:
Unassembled Fittings
1. Install the appropriate barb
fitting straight or 90° into the
¾" connector nut. Place the
sealing washer into the con-
nector nut afterwards.
2. Install the hose clamp loosely
on the discharge hose and
install the hose onto the
barb. Tighten the hose clamp
securely.
3. Thread the assembled con-
nector nut onto the pump
discharge port, position the
hose and tighten the connec-
tor nut. Tighten the assembly
¼ turn past hand tightness.
Pre-assembled fittings
1. Install the hose clamp loosely
on the discharge hose. Install
the hose onto the barb fitting
and position as neces-
sary. Tighten the hose clamp
securely.
2. Check the tightness of the
connector nut.
Threaded nuts do not require
mechanical tightening. Do
not over tighten, damage may
occur.
Marine type sealants are not requi-
red, periodic check for tightness is
recommended.
8
Original instructions