BFT LUX BT Instrucciones De Uso Y De Instalacion página 10

ENGLISH
• If the motor vibrates but does not turn, this may be due to:
• Wire connection wrong (check with the wiring diagram).
• if the leaf moves in the wrong direction, invert the drive connections of
the motor in the control unit LEAF STOP.
17.2) Faulty operation of the electrical accessories
If any of the control and safety components are faulty, this can cause mal-
functions or a breakdown of the whole automation.
If the control unit is equipped with a self-diagnostics system, identify the
fault.
In case of a fault, it is wise to disconnect each of the components in the
automation one at a time, until the one that is causing the fault is found.
After having repaired or replaced it, restore all the components that
were disconnected. For details on each component, refer to its specific
instruction manual.
WARNING: Any malfunction should be corrected immediately by a qualified
specialist. When carrying out maintenance operations, the area around the
gate should be well marked and barred in order to prevent accidents to
people, animals and objects.
WARNINGS:
Trouble-free operation of the controller can only be guaranteed if the data
given in this manual is respected.
The manufacturer is not liable for damages caused by the failure to respect
safety rules, installation recommendations and instructions given in this
manual.
18) MAINTENANCE
All maintenance on the controller must be performed with the system's
power supply shut off.
To top-up the oil proceed as follows: (Fig.22)
19) SCRAPPING
Warning: This operation should only be carried out by qualified person-
nel.
Materials must be disposed of in conformity with the current regulations.
In case of scrapping, the automation devices do not entail any particular
risks or danger. In case of recovered materials, these should be sorted out
by type (electrical components, copper, aluminium, plastic etc.).
20) DISMANTLING
Warning: This operation should only be carried out by qualified person-
nel.
When the automation system is disassembled to be reassembled on another
site, proceed as follows:
• Disconnect the power supply and the entire external electrical instal
lation.
• In the case where some of the components cannot be removed or are
damaged, they must be replaced.
The descriptions and illustrations contained in the present manual are
not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product fea-
tures unchanged, at any time and without undertaking to update the
present publication.
10 -
LUX BT
INSTALLATION MANUAL