Flash Mode Setting Parameters - Sony UPX-C300 Manual De Instrucciones

Flash Mode Setting Parameters

The flash mode is factory set to Program, but you can change the setting using the menus if necessary. The shooting
conditions available for configuration differ depending on the flash mode setting, as shown in the table below.
Flash Mode
Controlled Flash Program with Zoom and EV
without pre-flash
Forced Flash
without pre-flash (100/70/50/35/25/18/12%)
Exhibit Flash
: Default setting
Effects of the F value while shooting
Even if the F value is changed through zoom operations, the flash intensity level and ISO sensitivity are automatically
adjusted before shooting to ensure that the brightness of a captured image will not be affected.
8
System Overview
Flash Control Aperture
Fixed
(F4.7)
7 steps F4.7
(F4.7 or F5.6)
without Preflash
No Lighting F4.7
(F4.7 or F5.6)
Shutter Speed White Balance
Fixed Program
(1/250)
1/250 Program, 3000 to
(1/2 to 1/1000 [s]) 7000K or OnePush
1/250 Program, 3000 to
(1/2 to 1/1000 [s]) 7000K, OnePush
Exposure
Compensation
–2.0EV to 0EV to
+2.0EV (in 1/4EV
steps)
–1.0EV to 0EV to
+2.0EV (in 1/4EV
steps)
–1.0EV to 0EV to
+2.0EV (in 1/4EV
steps)