Connection; Setting Up The Printer; Setting The Slide Switches On The Paper Tray - Sony UP-895 Instrucciones De Uso

Connection/Setting Up the Printer

Connection

Notes
• Turn off the power to each device before making any
connections.
• Connect the AC power cord last.
Video equipment
to video output
connector
Supplied coaxial connecting
cable (BNC y BNC)
to VIDEO IN
DIP SW
REMOTE
UP
DOWN
to REMOTE
RM-91 Remote control unit
(not supplied)
22
Preparation
Color/black and
white video monitor
to video input
connector
Connecting cable
(not supplied)
to VIDEO OUT
t IN T OUT
VIDEO
AC IN
to AC IN
Supplied AC
power cord
to wall outlet

Setting Up the Printer

You can set the printer to the desired specifications using
two kinds of switches.
• Slide switches on the paper tray inside the front door
You can easily set the printer specifications most
frequently used in daily operation, such as selection of
the paper type and printout quality.
• DIP switches on the rear panel
You can set the print mode and other settings you do
not need to change frequently
Setting the Slide Switches on the
Paper Tray
The factory settings are as follows.
SHARPNESS GAMMA
OFF
1 2
A SHARPNESS switch
Adjusts the sharpness of the printout.
OFF: Not to emphasize an outline of the printout, set
the switch to this position.
I, II, III: To make a sharper outline, set the switch to
the proper position. In I, II and III order, the printout
becomes sharper.
PAPER TYPE SMOOTHING
OFF ON
S HD HG
3 4