Technical Specifications - Metabo KHE 5-40 Instrucciones De Manejo

en ENGLISH

12. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P = Rated input power
1
P = Power output
2
I = Current at 120 V
120 V
T = Torque
n = No-load speed
1
D = Max. drilling diameter in concrete with
1
impact masonry bits
D = Max. drilling diameter in concrete with
2
impact core cutters
D = Max. drilling diameter in concrete with
3
milling cutters
s = Maximum impact rate
max
W = Single impact force
S = Impact performance
C = Number of chisel positions
m = Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (hammer drilling
h, HD
into concrete)
a = Vibration emission value (chiselling)
h, Cheq
K = Uncertainty (vibration)
h,HD/Cheq
Wear ear protectors!
8