Setting Up Your Planar 1 Plus
•
Carefully unpack the turntable, always keeping it upright.
•
Check the belt is fitted around the drive pulley (A) and sub-platter (B).
•
Remove the packing card (C) from beneath the sub-platter (B) and fit the
platter (1) and mat.
•
Push the balance weight (4) fully onto the rear of the tonearm (3) until it
reaches the stop point as shown (D).
•
Connect the phono output to an appropriate line level input (see page 2).
•
Connect the power supply to the rear of the turntable (see page 2).
•
Carefully remove the stylus guard from the cartridge (2).
•
Turn on the Planar 1 Plus via the on/off switch located on the underside of
the plinth (5).
•
Change the speed by moving the drive belt from the 33 1/3 and 45 steps of
the pulley (A).
•
The RB110 tonearm (3) is preset for bias adjustment, no other set-up is
required.
1
5
(the on/off switch is located
underneath the plinth)
•
IMPORTANT: Please turn down the volume on the amplifier before
switching the unit on or off.
A, B & C
(located
beneath the platter)
2
D
4
3
33 1/3 RPM
45 RPM
Stop point
A
B
C
A
D
1