AND UA-779 Manual De Instrucciones página 6

Preparation for Measurements
1. Installing / Changing the Batteries
Remove the battery cover and insert
new batteries into the battery
compartment as shown, taking care to
observe the proper direction for each
battery. Use R6P, LR6, AA, or similar
type batteries.
If the symbol
depleted. Always change all batteries at the same time. If you do not intend to
use the device for longer periods, remove the batteries. Only use high quality,
leakproof batteries with the specified ratings. Never mix new and old batteries
or batteries from different manufactures. Used batteries do not fall within the
category of household waste, and must be disposed of according to the
applicable regulations.
2. Connecting the Air Hose
Insert the air connector plug into the air socket firmly.
3. Attaching the Arm Cuff
Wrap the cuff around the upper arm
about 2-3 cm above the elbow as shown.
Place the cuff directly against the skin, as
clothing may cause a faint heart beat, and
result in an error. Constriction of the
upper arm caused by rolling up a shirt
sleeve may prevent accurate readings.
4. Posture While Measuring
Remain seated in a comfortable position,
placing the center of the upper arm at the
same height as your heart.
5. Measurement
During the measurement, the cuff will
become very tight. Do not be alarmed as this is normal.
6. After the Measurement
After the measurement, remove the cuff and record your data.
appears on the display panel, this means that the batteries are
ENGLISH 5
Left arm
Hose
2-3 cm
Excessive
constriction