Care And Maintenance - Rothenberger ROMAX 3000 Instrucciones De Uso

3 Keep button pressed and remove the battery.
4
Disconnect mains power plug from the mains
power socket.
Storage:
The place of storage must be inaccessible for
children.
1 Keep button pressed and remove the battery.
2
Disconnect mains power plug from the mains
power socket.
3 Store battery charger in a dry, frost-proof
place.
Store the battery only in a charged state! Fully
recharge the battery after 12 months of storage, at
the latest!
Troubleshooting:
Before eliminating faults, disconnect the
mains power plug!
- Fault lamp (4) is lit red:
Battery temperature outside the permissible
charging temperature (5°C to 45°C).
- Fault lamp (4) flashes red:
Battery is defective.
If the battery temperature is between 5°C and
45°C and the red fault lamp (4) is nevertheless lit,
there may be a faulty contact.
- Clean contact points on battery.
In the event of other faults, please contact
ROTHENBERGER Service. Repairs should only be
carried out by ROTHENBERGER service centres or
dealers authorised by ROTHENBERGER.

Care and Maintenance

ROMAX 3000:
Remove the battery prior to carrying out any work
on the machine.
Check that the press jaws are fully functional.
Damaged press jaws must not be used and must
be sent to an authorised ROTHENBERGER repair
shop.
Check that the press jaw and drive rolls move
freely.
Check the bolt for signs of damage at regular
intervals. Have damaged bolts replaced by an
authorised ROTHENBERGER repair shop.
Clean and grease the drive rolls, the bolt and press
jaws when you have finished work.
Use only high quality pressing or ball bearing
grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work
must be carried out by an authorised
ROTHENBERGER repair shop.
If the seal is damaged the warranty will be null and
void.
After 20.000 pressing cycles or 2 yeas have the
machine serviced by an authorised ROTHENBERGER
workshop.
When dispatching the machine ensure that it is
packed in its carrying case completely with battery
and charger in the carry case only.
Electro-hydraulic machine does not exceed 3 hours
in a -5° C storage.
Disconnect battery from machine before storing.
Charger:
If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed
by the manufacturer, because special purpose tools
are required.
Accessories
The relevant accessories and an order form can be
found from page 122 onwards.
Disposal
Components of the unit are recyclable material and
should be put to recycling. For this purpose
registered and certified recycling companies are
available. For an environmental friendly disposal of
the non-recyclable parts (e.g. electronic waste)
please contact your local waste disposal authority.
Old batteries can be taken to your specialist dealer
who will dispose of them in conformity with
environmental regulations.
For EU countries only:
Do not dispose of electric tools with
domestic waste. In accordance with
European Directive 2002/96/EC on
waste electrical and electronic
equipment and its implementation as national law,
electric tools that are no longer serviceable must be
collected separately and utilised for
environmentally compatible recycling.
Used removable batteries must not be thrown in
fire or in the household rubbish.
ENGLISH
13