Troubleshooting; Technical Data - GreenWorks Pro LMB401 Manual Del Operador

The machine has a storage switch (23) that prevents its
startup in the storage position.
It is necessary to remove the safety key and the battery
pack to prevent accidental startup or unapproved use.
The storage switch does not replace this function.
10

TROUBLESHOOTING

Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery ca-
does not start. pacity is low.
The bail switch is
defective.
The battery key
is not put in.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
English
Problem
There is a high
vibration in the
machine.
Solution
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
switch.
The machine
Put in the battery
stops during
key.
mowing.
Examine the
mowing area.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries be-
fore mowing.
Install the mulch
plug.
Increase the
* If you cannot find the solution to these problems, go to
blade height.
the service center.
11
Empty the grass
clippings from
Voltage
the grass catch-
er.
No load speed
Deck Size
Height adjustments
Functions
Weight (without bat-
tery pack)
Battery model
Charger model
Double insulated
construction
13
Possible cause
The blade is un-
balanced and
worn.
The motor shaft
is bent.
The blade height
is too low.
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.

TECHNICAL DATA

80 V
2800 RPM
21"
1 3/8 - 3 3/4" (3.5 - 9.5) cm
3-in-1Rear bag & Side Dis-
charge & Mulch
25.5 kg (56.2 lbs)
2901302 and other BAB series
2901402 and other CAB series
EN
Solution
Replace the
blade.
1. Stop the mo-
tor.
2. Remove the
safety key
and battery
pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine be-
fore you start
it again.
Increase the
blade height.
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.