Store The Machine; Vertical Storage; Troubleshooting - GreenWorks Pro MO60L05 Manual Del Operador

EN
7. Remove the blade.
8. Install the new blade. Make sure that the arrows engage
the holes in the blade.
9. Put in the mounting screw and spacer and tighten them.
Recommended tightening torque: 24-27 ft.lbs.
8.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
8.4

VERTICAL STORAGE

1. Remove the grass catcher.
2. Remove the battery and safety key.
3. Pull and turn the handle knobs 90.
4. Fold down the handles.
5. Turn the handle knobs 90° to lock the handle into
position.
6. Stand the machine on end and make sure that the brackets
touch the floor.
English
9

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
12
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
bolts and nuts are
aligned correctly.
The battery ca- Charge the battery
pacity is low. pack.
The start handle is Replace the bail
defective. switch.
The battery key is Put in the battery
not put in. key.
The lawn is rough. Examine the mow-
ing area.
The blade height is Move the wheels
not set correctly. to a higher posi-
tion.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade
tall, or the blade height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
The blade is un- Replace the blade.
balanced and
worn.
The motor shaft is 1. Stop the mo-
bent. tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.