Store The Machine; Vertical Storage; Troubleshooting - GreenWorks Pro MO60L03 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Turn nut (24B) to the left to remove blade B (21),
spacer (25B) and positioner (23).
7. Install the new blade. Position the blade with the
cutting edges toward the ground. Make sure the two
posts on positioner engage the holes on the blades.
8. Assemble the positioners and spacers as shown.
Positioner (22) for blade A only; positioner (23) for blade
B only. Mounting nuts and spacers of blade A are
interchangable with that of blade B.
9.3

STORE THE MACHINE

Clean the machine before storage.
Make sure the motor is not hot when you store the
machine.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved service
center.
Store the machine in a dry area.
Make sure that children cannot come near the
machine.
9.4

VERTICAL STORAGE

1. Remove the grass catcher.
2. Remove the battery and safety key.
English
3. Pull through the handle holes to fold away the
handles.
4. Lock the handles into position.
5. Stand the machine on end and make sure that the
brackets touch the floor.
10

TROUBLESHOOTING

Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
The machine is
hard to push.
13
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the bolts
and nuts are
aligned correctly.
The battery ca-
Charge the bat-
pacity is low.
tery pack.
The start handle
Replace the bail
is defective.
switch.
The battery key
Put in the battery
is not put in.
key.
The lawn is
Examine the
rough.
mowing area.
The blade height
Move the wheels
is not set cor-
to a higher posi-
rectly.
tion.
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
The grass is too
Increase the
tall, or the blade
blade height.
height is too low.
The grass catch-
Empty the grass
er and the blade
clippings from
drags in thick
the grass catch-
grass.
er.
EN

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Lmc406

Tabla de contenido