Troubleshooting - Worx JAWSAW WG320 Manual De Instrucciones

TROUBLeSHOOTInG

If your saw does not operate correctly check the following:
PRoBLEMS
• Tool will not start.
• Bar / chain overheated.
• Chain is loose.
• Poor cut quality.
22 22
• Unit runs but does not cut.
Cordless Limbing and Trimming Chain Saw en
PoSSiBLE CauSES
• Out of battery.
• Chain too tight.
• Lubrication needed.
• Chain tension set incorrectly.
• Chain tension set incorrectly.
• Chain needs replacement.
• Chain installed backwards.
See Fig. H and illustration.
PoSSiBLE SoLuTioN
• Charge the battery pack.
• Refer to adJuSTiNg THE
CHaiN TENSioN section.
• Refer to LuBRiCaTioN
section.
• Refer to adJuSTiNg THE
CHaiN TENSioN section.
• Refer to adJuSTiNg THE
CHaiN TENSioN section.
NoTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
• Refer to sections for
CHaNgiNg THE guidE
BaR aNd CHaiN.
• Refer to CHaNgiNg THE
guidE BaR aNd CHaiN
section.