Initial Settings; Adjusting Initial Settings; Setting The Clock; Turning The Off Clock Display On Or Off - Pioneer DEH-P6000UB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
04

Initial Settings

Adjusting initial settings

1
Press SRC and hold until the unit turns
off.
2
Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3
Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)—OFF CLOCK (off clock)—
FM STEP (FM tuning step)—AUTO PI (auto PI
seek)—WARNING TONE (warning tone)—
AUX1 (auxiliary input 1)—AUX2 (auxiliary
input 2)—DIMMER (dimmer)—SW CONTROL
(rear output and subwoofer controller)—
DEMO MODE (feature demo)—EVER SCROLL
(ever scroll)—BT AUDIO (Bluetooth audio)—
PIN CODE INPUT (pin code input)—
BT VER INFO (Bluetooth version information)
—TITLE SETTING (multi language)
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND/ESC.
# BT AUDIO, PIN CODE INPUT and
BT VER INFO can be selected only when Blue-
tooth adapter (e.g., CD-BTB200) is connected to
this unit.

Setting the clock

Use these instructions to set the clock.
1
Use MULTI-CONTROL to select
CLOCK SET.
2
Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press MULTI-CONTROL, one
segment of the clock display is selected.
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
30
En
4
Turn MULTI-CONTROL to put a clock
right.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Turning the off clock
display on or off
If the off clock display is turned on and the
sources and the feature demo are off, the
clock display appears on the display.
1
Use MULTI-CONTROL to select
OFF CLOCK.
2
Press MULTI-CONTROL to turn the off
clock display on.
# To turn the off clock display off, press
MULTI-CONTROL again.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1
Use MULTI-CONTROL to select FM STEP.
2
Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3
Turn MULTI-CONTROL to select the FM
tuning step.
Turning MULTI-CONTROL switches the FM
tuning step between 50 kHz and 100 kHz while
AF or TA is on. The selected FM tuning step ap-
pears in the display.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Note
The tuning step remains at 50 kHz during manual
tuning.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido