HumanTechnik introsonIR Instrucciones De Servicio página 6

Standard components
Please check if all listed items are included:
- introson - Transmitter and Receiver
IR
- 12 V plug-in PSU
- Connection cable
- Operating Instructions
- Warranty card
If any parts are missing please immediately contact your dealer or the manufacturer directly.
Connecting the infrared transmitter
- Plug in the audio connection cable
nection jack of the transmitter and the other end into the connection jack of your sound
source (e.g. the TV).
Other connection adapters are available optionally: a 3.5-mm stereo cinch jack adapter
which can be connected to a headphone jack, or a SCART connector
plugged into the SCART jack of the audio source (marked with AV).
If your sound source is not equipped with a headphone jack or any other connection op-
tions, then you can clip a microphone
plugged into the corresponding MIC jack on the transmitter. The microphone is sold se-
parately.
- Connect the power cord that comes with the device
connection plug. Then plug the power cord itself into a 230V electrical wall outlet.
- Set the under-the-chin receiver into the charging tray of the transmitter without using any
excessive force
- Before the device is used for the first time, the receiver with the built-in rechargeable bat-
tery should be charged for 24 hours.
Setting up or adjusting the transmitter
- Place the transmitter close to the sound source in a suitable position. There must be a
clear line of sight between the front of the transmitter (polished front surface
receiver . The polished surface of the transmitter must be aimed at the front of the
8
transmitter.
Using the receiver
- Use the volume control
ing. Turn the volume control in the direction of the "6" to increase the volume and in the
direction of the "0" to decrease the volume.
- Use the sliding switch
device "ON" or "OFF". Make sure that the sound source connected is switched on and
adjust the volume on the receiver to a level that is comfortable for you.
6 English
. A red LED will light up to indicate that the device is being charged up.
6
to initially set the receiver to a low volume to protect your hear-
9
, on the rear side of the under-the-chin receiver to switch the
10
that comes with the device into the "LINE IN" con-
1
onto the sound source. This microphone is then
4
to the transmitter using the "DC12V"
5
2
, which can be
3
) and the
7