HumanTechnik Signolux S Instrucciones De Servicio página 10

We would like to congratulate you on pur-
chasing a »signolux«. You have chosen a
modern and reliable system. Kindly read
the user manual carefully in order to start
using the device properly and to familiarise
yourself with all the possibilities of the sys-
tem.
Standard delivery scope
Kindly check if all following parts are
included:
– »signolux« receiver S
– 4 rechargeable batteries size AA / HR6
– Power supply unit
– Wall mount
– 2 screws
– 2 wall plugs
– Operating manual
– Warranty card
Should any parts be missing, kindly contact
your specialist dealer or the manufacturer
directly.
Functioning principle
A »signolux« light signal system consists
of at least one transmitter (e.g. doorbell
pushbutton) ad a »signolux« receiver. Up
to 8 transmitters can be assigned to each
event icon.
If e.g. the doorbell pushbutton is pressed, a
radio signal (radio impulses at 868,35 MHz)
are transmitted to the »signolux« receiv-
er. This one signals the received signals
acoustically and visually with sounds and
light signals.
Safety instructions
– Prior to putting the device into operation
and using it, kindly read this manual thor-
oughly and in full.
– Store this operating manual in a safe
place so that it is also accessible for other
users at any time.
10 English
– When using power tools always follow the
instructions of the manufacturer and wear
suitable protective equipment (e.g. pro-
tective goggles).
– Kindly check before starting to drill if there
are any hidden electric cables and water
pipes in the walls. In case of doubt we
recommend using a a cable detector.
Setup
1. Inserting the rechargeable batteries
into the »signolux« receiver
a) At the rear side there is a battery com-
partment, its cover can be pushed
downwards so that the compartment
opens ( fig. 1).
Figure 1: Battery compartment
b) Now insert the 4 rechargeable batteries
(included). Ensure correct polarity of the
batteries.
c) Close the battery cover again by insert-
ing the cover and pushing it upwards.
d) Connect the power supply to the receiv-
er. The time needed for a full charge is
approximately 6 hours.