Welby BDH 612 Manual Del Usuario página 37

5. The pump will stop pumping once the pressure gradually declines. During this
phase, the blood pressure and pulse of the user will be calculated as shown in Fig. 5.
6. The air in the cuff will be quickly released and the measurements for the blood
pressure and pulse will be shown on the display. The indicator of the memory
group for a user (M1, M2)
surements as shown in Fig. 6.
7. Push the M1 or M2 button
time will also be shown on the display in alternation (see Fig. 6). If the user does not push the M1 or M2
button, the measurements will not be saved.
8. Push the Start/Stop button to switch the device off. Please take a break of at least 5 minutes before you
take another measurement. If the power supply is not switched off and the device is not used for
3 minutes, it will automatically switch off with a signal.
20
will then blink to remind the user to save the mea-
9 7
/ to save the measurements to the respective memory. The measuring
Performing a measurement
Fig. 5
Fig. 6
37