Starmix AirStar T 80 Instrucciones De Montaje página 10

5. Mounting sequence.
1. Use a screwdriver to disengage the panel under the
blow-out connection 5 (above the rating plate).
Unscrew the two screws in the air intake filter 2 and
push back the blow-out outlet slightly.
2. Swivel up the top section 1 and remove.
3. After the installation point has been decided, use the
mounting stencil to mark out the drilling holes (8 mm
dia.) for 3 dowels. The appliance is supplied with
screws and dowels. The most favourable mounting
height is 1.15 m (blow-out outlet from the floor) for the
T 80 and T 80 E appliances, and 2.0 m for the
TH 80 Z. Observe the mounting stencil for the power
supply cable entry point.
4. Insert the power supply cable. Secure the base
section 3 to the wall. Conduct the power supply cable
with a water run-off loop and connect to the mains
terminal at the top on the left-hand side. Refer to the
circuit diagram for the electrical connection.
5. The running time of the electronic timer is works
adjusted to approx. 0.5 min for the T 80, and to
4 minutes for the TH 80 Z. This setting can be changed
between a range of 0.5-8 min by turning the potentio-
meter setting screw clockwise (accessible through the
hole over the heater when the top section is open).
The switching distance for the T 80 E – The distance
between the bottom edge of the device and the hands or
head. An expert can change this distance by turning the
adjusting screw (accessible under the heater when
the upper section is open) anti-clockwise (shorten) or
clockwise (lengthen).
6. Insert the air intake filter 2 and blow-out outlet 5 in
the corresponding guides before the appliance is closed.
Place the top section 1 on the base section 3 and
press firmly together.
Push the blow-out outlet right to the front and secure
with the two screws (+ washers).
7. Press the panel over the rating plate back in.
For safety reasons always ensure that mains
fuses are switched off prior to all interventions.
Trial runs must only be completed with a
closed hood, otherwise the heater will not be
sufficiently cooled.
10
6. Setting the height for the Starmix
TH 80 Z hair dryer.
The robust, attractively styled Starmix THH 80 height
adjustment, Order No. 11 10 01, ensures
that the hair dryer can be easily set to the height of any
individual. This also greatly simplifies hair drying for
children and people in wheelchairs.
As an alternative it is also possible to mount two hair dryers
with 40 cm difference in height.
7. Cleaning and care.
The suction filter 2 at the base must be cleaned periodi-
cally with a vacuum cleaner crevice nozzle to remove fluff
and dust. Use a brush to remove grime firmly adhering in
the filter openings.