HIKOKI CN 18DSL Instrucciones De Manejo página 6

English
● Regarding the temperatures and charging time of the battery.
The temperatures and charging time will become as shown in Table 2.
Battery
Charging voltage
Weight
Temperatures at which the battery can be recharged
Charging time for battery capacity, approx.(At 20oC)
1.3 Ah
1.5 Ah
2.0 Ah
2.5 Ah
3.0 Ah
4.0 Ah
5.0 Ah
Number of battery cells
*1 AC power supply / DC 12 V (in-car) power supply
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
<UC18YML2>
Especially, using a DC 12 V in-car power source may
require longer recharging time at high temperatures.
CAUTION
When the battery charger has been continuously used,
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
4. Disconnect the charger's power cord from the
receptacle or cigarette lighter socket.
5. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
CAUTION
○ If the battery is charged while it is heated because it has
been left for a long time in a location subject to direct
sunlight or because the battery has just been used,
the pilot lamp of the charger lights up green or lights
for 1 second, does not light for 0.5 seconds (off for
0.5 seconds). In such a case, fi rst let the battery cool,
then start charging.
○ When the pilot lamp fl ickers in red (at 0.2-seconds
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery or charger is
malfunctioning. Take it to your authorized Service
Center.
○ Since the built-in micro computer takes about 3
seconds to confi rm that the battery being charged with
charger is taken out, wait for a minimum of 3 seconds
before reinserting it to continue charging. If the battery
is reinserted within 3 seconds, the battery may not be
properly charged.
○ Check the voltage of the in-car power source when
the pilot lamp fl ickers in green (every 0.2 seconds)
continuously. (UC18YML2)
If the voltage is 12 V or lower, it indicates that the car
battery has weakened and cannot be charged.
○ If the pilot lamp does not blink in red (every second) even
though the charger cord or cigarette lighter connecting
plug is connected to the power, it indicates that the
protection circuit of the charger may be activated.
Table 2
Charger
UC18YFSL
V
kg 0.5
min. 20
min. 22
min. 30
min. 35
min. 45
min. 60
min. 75
Remove the cord or plug from the power and then connect
it again after 30 seconds or so. If this does not cause the
pilot lamp to blink in red (every second), please take the
charger to the HiKOKI Authorized Service Center.
MOUNTING AND OPERATION
Removing and inserting the battery
Charging
Replacing punch and die*
Switch operation
Remaining battery indicator
Cutting plates
Pocket cutting
Switch cutting direction
Cutting corrugated and trapezoidal
plates
Selecting accessories
*1 Punch and die replacement (see Fig. 3)
CAUTION
During the following operations, use care to prevent dirt
adhering inside the gear cover ⓐ, inside the die holder
ⓑ and around the piston.
(1) Punch ⓒ replacement
(a) Loosen the M8 hexagon socket set screw ⓓ
mounting the die holder and remove the die holder.
(b) Loosen the M5 hexagon socket set screw ⓔ
fastening the punch to the piston ⓕ and pull out the
punch ⓒ.
(c) Insert the new punch ⓒ while aligning the taper hole
ⓖ of the punch and the direction of the M5 hexagon
socket set screw, then securely tighten the hexagon
socket set screw.
(2) Die ⓗ replacement
Loosen the 2 machine screws ⓘ and replace the die
ⓗ.
(3) Lubricaton
When the above replacement operations are
completed, apply a suitable amount of machine oil
to the sliding surfaces around the punch and die and
operate the machine without a load.
6
UC18YML2
(AC/DC)*
14.4 – 18
0.7
0oC – 50oC
20 / 50
22 / 60
30 / 80
35 / 100
45 / 120
60 / 160
75 / 200
4 – 10
Action
1
1
Figure Page
1 174
2 174
3 174
4 175
5 175
6 175
7 176
8 176
9 176
― 178