Metrohm 756 KF Instrucciones Para El Uso página 96

4.2 Remote control commands
88
.UnitFlow: Unit of gas flow.
4.2.2.74. Info.ActualInfo.Display.L1
Info.ActualInfo.Display.L8
Info.ActualInfo.Display.DelAll
Lines of the display. The display can be written to from the computer. Proceed as
follows:
1. Lock the display, see 4.2.2.90.
2. Delete the whole display (.DelAll).
3. For writing onto the display, the standard character set will be used.
4. Unlock the display, see 4.2.2.90
5. Delete the whole display (.DelAll).
6. Send a value to nod &Config.Aux.ResDisplay (see 4.2.2.47) to refresh the dis-
play.
$Q sends the contents of the corresponding display line.
4.2.2.75. Info.ActualInfo.Comport.Number
$Q sends the comport number of the Coulometer where the PC is connected.
4.2.2.76. Info.Assembly.CycleTime
Info.Assembly.ExV
Info.Assembly.DeviceTemp
Inquiries regarding basic variables of the assembly.
.Cycle time: Time of measuring cycles in s (0.4).
.ExV: Volume of the Dosing Unit of the connected Dosino in mL.
.DeviceTemp: Internal temperature of Coulometer in °C.
4.2.2.77. Assembly.GenEl.Pulse
Assembly.GenEl.Pulse.Length
Assembly.GenEl.Pulse.Current
Control of the generator electrode. The pulse will be generated with &A.G.P$G.
.Length: Length of pulse in 2000 steps. 2000 means a pulse of 400 ms (e.g. a
pulse of 150 ms would mean 750 steps).
.Current: Current for pulse in mA.
4.2.2.78. Assembly.Meas.Status
Assembly.Meas.Ipol
Control of the indicator electrode. When the measuring function is switched on, no
method can be started at the Coulometer.
.Ipol: Polarization current in uA.
4.2.2.79. Assembly.Outputs.AutoEOD
Assembly.Outputs.SetLines
Assembly.Outputs.SetLines.L0
up to .L13
Assembly.Outputs.ResetLines
up to 32 ASCII characters
up to 32 ASCII characters
read only
read only
read only
read only
0...2000
0, 100, 200, 400
ON, OFF
2, 10, 20, 40
ON, OFF
active, inactive, pulse, OFF
756/831 KF Coulometer, Instructions for Use
$G
$G
$G
$G