SMA SUNNY HIGHPOWER PEAK1 Instrucciones De Instalación página 35

SMA Solar Technology AG
ID Status
message
2052,
2053
2054
2055 Fallback
activated
2056 Fallback
completed
Table 4.3 System-related events
Internal Events
ID Status
message
201–
208
209,
210
211 Low fan
speed
213–
215
216–
218
Installation Guide
Description
Transmission of the Grid Code
from the SMA Inverter
Manager to the inverter has
started/ended.
Transmission of the Grid Code
from the SMA Inverter
Manager to the inverter has
failed.
The inverter switched to the
fallback mode after the
communication with the SMA
Inverter Manager was
interrupted.
The inverter has switched back
to normal operation after
having been in the fallback
mode due to a communication
disturbance with the SMA
Inverter Manager.
Description
The internal temperature of the
inverter is too high.
Voltage in DC link is too high.
Fan speed is too low.
Internal error. Voltage
measured before and after the
relay differs too much.
Current measured on AC side
is too high.
Measure
-
If this event occurs frequently,
contact Service.
Measure
Verify that no objects or dust are on
top of the inverter and make sure
that the air ducts are clear and not
blocked.
If the event persists, reset the
inverter by disconnecting DC and
AC. If the event is repeated, check
the maximum PV voltage using the
display to see if it is above the limits.
Check whether the inverter fan is
blocked.
Contact the service.
Contact the service.
4 Service
DNO SMA
Service
Line
- -
- -
- -
- -
DNO SMA
Service
Line
- x
- x
- x
- x
- x
SHP75-10-IA-xx-15
PV
-
-
-
-
PV
-
-
-
-
-
35