Specific Safety Rules - Panasonic EY4541 Manual De Instrucciones

5) Under abusive conditions, liq-
uid may be ejected from battery;
avoid contact. If contact acci-
dentally occurs, flush with wa-
ter. If liquid contacts eyes, addi-
tionally seek medical help.
Liquid ejected from the battery may
cause irritation or burns.
Service
1) Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of
power tool is maintained.
III. SPECIFIC SAFETY
RULES
1) Hold tool by insulated gripping
surfaces when performing an op-
eration where the cutting tool
may contact hidden wiring. Con-
tact with a "live" wire will also make
exposed metal parts of the tool "live"
and shock the operator.
2) Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the work by hand or against
your body leaves it unstable and
may lead to loss of control.
3) Keep hands away from cutting
area and blade. Keep your insu-
lated gripping surfaces. If both
hands are holding the tool, they
cannot be cut by the blade.
4) Never hold piece being cut in
your hands or across your leg.
It is important to support the work
properly to minimize body exposure
or loss of control.
5) Be aware that this tool is always
in an operating condition, since it
does not have to be plugged into
an electrical outlet.
6) Always use safety goggles or
glasses with side shields. Ordi-
nary eye or sun glasses are NOT
safety glasses.
7) When this tool is used for woodw
orking in confined areas (e.g. in-
doors), wear dust mask.
8) Avoid cutting nails. Inspect work-
piece for any nails and remove
them before operation.
9) Do not cut oversized workpiece.
10) Check for the proper clearance
beyond the workpiece before
cutting so that the blade will not
strike the floor, workbench, etc.
11) Hold the tool firmly.
12) Make sure the blade is not con-
tacting the workpiece before the
switch is turned on.
13) Keep hands away from moving
parts.
14) Do not touch the blade or work-
piece immediately after opera-
tion; they may be extremely hot
and could burn your skin.
15) Never swing tool.
16) Do not use blades which are de-
formed or cracked.
17) Do not use blades which do not
comply with the characteristics
specified in these instructions.
18) Remove the battery pack from
the tool body before replacement
of the blade, making adjustments,
or other maintenance work.
19) Wear ear protectors when using
the tool for extended periods.
Symbol
V
n
0
... min -1
Ah
- 6 -
Meaning
Volts
Direct current
No load speed
Revolutions or
reciprocation per minutes
Electrical capacity of
battery pack
To reduce the risk of injury,
user must read and under-
stand instruction manual.
For indoor use only.