Panasonic EY4541 Manual De Instrucciones página 8

8) Do not operate charger with dam-
aged cord or plug – replace them
immediately.
9) Do not operate charger if it has
received a sharp blow, been
dropped, or otherwise damaged in
any way; take it to a qualified ser-
viceman.
10) Do not disassemble charger; take
it to a qualified serviceman when
service or repair is required. In-
correct reassembly may result in a
risk of electric shock or fire.
11) To reduce the risk of electric
shock, unplug charger from out-
let before attempting any mainte-
nance or cleaning.
12) The charger and battery pack are
specifically designed to work to-
gether. Do not attempt to charge
any other cordless tool or battery
pack with this charger.
13) Do not attempt to charge the bat-
tery pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and bat-
tery pack in locations where the
tempera ture may reach or exceed
50°C (122°F) (such a metal tool
shed, or a car in the summer),
which can lead to deterioration of
the storage battery.
16) Do not charge battery pack when
the temperature is BELOW 0°C
(32°F) or ABOVE 40°C (104°F).
This is very important.
17) Do not incinerate the battery pack.
It can explode in a fire.
18) Avoid dangerous environment. Do
not use charger in damp or wet lo-
cations.
19) The charger is designed to oper-
ate on standard household electri-
cal power only. Do not attempt to
use it on any other voltage!
20) Do not abuse cord. Never carry
charger by cord or yank it to discon-
nect from outlet. Keep cord away
from heat, oil and sharp edges.
21) Charge the battery pack in a well
ventilated place, do not cover the
charger and battery pack with a
cloth, etc., while charging.
22) Use of an attachment not recom-
mended may result in a risk of fire,
electric shock, or injury to persons.
23) Do not short the battery pack. A
battery short can cause a large cur-
rent flow, over heating and burns.
24) NOTE: If the supply cord of this ap-
pliance is damaged, it must only be
replaced by a repair shop appoint-
ed by the manufacturer, because
special purpose tools are required.
25) TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, THIS APPLIANCE
HAS A POLARIZED PLUG (ONE
BLADE IS WIDER THAN THE
OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper out-
let. Do not change the plug in any
way.
- 8 -