Tools Needed For Assembly And Alignment - Bosch GCM12SD Instrucciones De Funcionamiento Y Seguridad

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:51 PM Page 14
Combination Square
1. Position square
and draw a light line
3/4" board with
straight top edge
14
Tools Needed For Assembly
6/4mm Hex Key
NOTE: A 6mm and a 4mm hex key can be
substituted for the supplied 6/4mm hex key.
Combination Square Must Be True -
Checking Combination Square
drawn line
#2 Phillips Screwdriver
(supplied)
no gap or overlap
2. Flip square (shown
in dotted position)
3. Check edge of
flipped square against
the drawn line. There
should be no gap or
overlap at the bottom
end.