Adding Detergent And Rinse Agent; Operating The Dishwasher - Bosch SHX46L Manual De Instrucciones

Adding Detergent and
Rinse Agent
1. Detergents
a) Use only detergents specifically
designed for dishwashers.
b) The detergent dispenser cup has
lines that measure detergent to 15
milliliters (mI) and 25mk 45ml of
detergent will completely fill the
detergent dispenser cup.
DISHWARE DAMAGE: Too much
detergent in soft water may cause
etching in glassware. Do not use too
much detergent if your water supply
is soft.
NOTE: If you do not know the
hardness of your water supply, use 15mi
of detergent. Increase the amount of
detergent, if necessary, to the least
amount required to get your dishware
and kitchenware clean.
c) Use the measuring lines in the
detergent dispenser cup as a guide to
measure the amount of detergent
recommended in Table 1.
Tabb 1
Wash
Cycme Hard
Power
Scrub 45mi
Plus
Regular 25-45ml
Wash
Delicate/ 25mi
Econo
Rinse &
Hold None
Water Type
Medium Soft
45ml 25-45ml
25ml 15-25mi
15-25ml 15ml
None None
2. Rinse Agents
a) Always use a liquid rinse agent,
even if your detergent contains a rinse
agent or drying additive.
3. The Detergent and Rinse Agent
Dispenser
= Filling the Detergent Dispenser
a) Fill the dispenser cup as
recommend in Table 1.
b) Slide the detergent dispenser cover
in the direction shown in Figure 14A and
)tess it down firmly as shown in Figure
14B so that the cover snaps shut.
USING YOUR DISHWASHER
Figure 14
i:iiiiii i
- Opening the Detergent Dispenser
Cover
NOTE: To open the detergent
dispenser cover, press the bmue reBease
in the direction shown in Figure 15.
Pressing down on the release tab will
not open the cover.
c) Press the blue release tab in the
direction shown by the arrow in Figure
5.
Figure 15
d) The cover will slide open to the right.
- Filling the Rinse Agent Dispenser
e) Open the rinse agent dispenser by
pressing the star on the cover with your
index finger while lifting the tab with your
thumb as shown in Figure 16.
r
Figure 16
k_
t) Add liquid rinse agent to the
dispenser as shown in Figure 17A until
the rinse agent reservoir is full. Wipe up
any excess rinse agent that puddles
when the dispenser reservoir is full.
Figure 17
9') Return the rinse agent dispenser
cover to its shut position and press it
firmly so that the cover snaps shut.
NOTE: Figure 17B represents a
compmete_y empty rinse agent
reservoir,
h) Refill the rinse agent dispenser
when the rinse agent reservoir level
indicator as shown in Figure 17B
begins to show a silver background with
black lines or when the Refill Rinse
Agent indicator comes on.
NOTE: After fiIIing the rinse agent
dispenser, the Refill Rinse Agent
indicator wil! go out in a few minutes after
the dishwasher door is shut.
- Rinse Agent Dispenser Regulator
The amount of rinse agent dispensed
can be regulated to control spotting and
streaking. The Rinse Agent Dispenser
Regulator as shown in Figure 18 leaves
our factory set at 4.
Figure 18
To adiust the amount of nnse agent
dispensed:
i) Open the rinse agent dispenser
cover.
/} if your dishes are streaked after
washing, turn the regulator to a lower
number.
k) if your dishes are spotted after
washing, turn the regulator to a higher
number.
Operating the Dishwasher
1. Select the Proper Wash Cycle
a) Items with baked-on or hard, dried-
on soiling will require either Power
Scrub Plus or possibly soaking and
hand-scouring.
b) The Regular Wash cycle will
thoroughly dean large loads having
loosely attached normal soiling.
c) The Rinse and Hotd cycte wilI allow
you to keep a small load in your
dishwasher until you have enough items
for a full load=
7