Peaq PDR350BT-B Manual De Instrucciones página 55

ADJUSTING ANTENNA
For optimal reception, extend the antenna,
move to fully extend and adjust it.
Internet-radio
configuration
There are two ways to connect the radio to
the internet using an access point:
• Wireless in WLAN-Mode
The WiFi-antenna of the radio receives
your DSL router signals.
• With cable using the radio's LAN
connection in LAN-Mode provided an
ethernet network is available.
WLAN-MODE CONFIGURATION
If you have a wireless network, the WLAN
mode is the direct way to connect your radio
to the Internet:
1. Simply switch the radio on and, as a
cable-free network client, it automati-
cally searches all available APs (Access
Points).
IM_PDR350BT_1_150930_V04_HR.indb 55
2. When switching on for the first time, you
must confirm the AP and perhaps enter
the key. After that, the radio will always
access this AP. If the AP can no longer
be found, it will be registered accord-
ingly.
LAN-CONFIGURATION
If you do not have a wireless network but do
have a cabled network, you can connect the
Internet radio with a network.
1. Switch the radio off.
2. Connect an Ethernet cable to the LAN
socket. Once switched on and choose
wired. The radio will automatically be
recognized as a cable client.
Operation
ON AND STANDBY
Press the button on the product or on the
remote control to switch on the product or to
standby mode.
ENGLISH
Welcome to
Internat Radio
STARTING...
55
30/9/15 4:38 PM