Disposal And Recycling; Carbon Brushes; Ordering Spare Parts - EINHELL BT-SH 3/10 Manual De Instrucciones

Anleitung_BT_SH_3_10_SPK7:_
GB
9.2 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.

9.3 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked by a qualified electrician. Important.
The carbon brushes should not be replaced by
anyone but a qualified electrician.
9.4 Maintenance
The grinding wheel must be replaced at the latest
when the grinding results start to deteriorate after a
certain time. To do so, please send the drill bit grinder
to the address below:
iSC GmbH
Eschenstraße 6
D-94405 Landau

9.5 Ordering spare parts

Please provide the following information when
ordering spare parts:
Model/type of unit
Article number of unit
ID number of unit
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30°C. Store the electric tool in its
original packaging.
10
23.11.2011 15:36 Uhr Seite 10

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.