Technical Data - EINHELL BT-SH 3/10 Manual De Instrucciones

Anleitung_BT_SH_3_10_SPK7:_
GB
Important.
When using equipment, a number of safety
precautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety information with due care.
Keep these operating instructions in a safe place so
that the information is available at all times. If you give
the equipment to any other person, hand over these
operating instructions and the safety information as
well. We cannot accept any liability for damage or
accidents which arise due to failure to follow these
instructions and the safety information.
1. Safety information
For the relevant safety information please refer to the
booklet included in delivery.
WARNING
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all the safety information and instructions
in a safe place for future use.
2. Layout (Fig. 1)
1. Handle
2. Drill bit guide hole
3. Opening for emptying grinding dust
4. On/Off switch
5. Power cable
3. Items supplied
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
present).
Check to see if all the items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, keep the packaging until the end of
the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
plastic sheets and small parts. There is a risk of
choking and suffocating!
8
23.11.2011 15:36 Uhr Seite 8
Drill bit grinder
Original Operating Instructions
Safety information
4. Intended use
The drill bit grinder is designed for grinding drill bits
for working with metal (HSS bits) with diameters of 3-
10 mm.
The equipment must be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Mains voltage: 230-240 V ~ 50 Hz
Power consumption: 55 W S3 50% 2 min
Idling speed:
Drill bit diameter:
Protection class:
Weight:
S3 50%: Intermittent mode, no start-up, no braking
(cycle duration 2 minutes). In intermittent mode, the
percentage load factor (50%) is always quoted so
that the heat generated during this period can be
dissipated during breaks in operation by convective
cooling. Intermittent mode consists of the on time and
the cooling breaks, known as the duty cycle. The
period of consideration is 2 minutes. 50% load factor
means that the electric tool can be operated for one
minute at the rated performance, followed by a
cooling phase of one minute.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
1500 min -1
3-10 mm
II / ®
2,1 kg