Connections - Omnitronic Kill-Mixer FX-524 Manual Del Usuario

When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Do not operate the device in extremely hot (more than 30° C) or extremely cold (less than 5° C)
surroundings. Keep away from direct insulation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

CONNECTIONS

• Make sure that the power switch is set to "OFF". Before you connect the devices, all units have to be
switched off and the master-control is set to "0".
• Make sure that the available voltage is not higher than stated on the voltage selector before you connect
the power-cord.
• In order to obtain highest sound-quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• You can connect up to 2 amplifiers to the FX-524. The output signal of the Master-signal can be adjusted
via the Master-control and the Balance-control. The output-signal of the Booth-signal can be adjusted via the
Booth-control.
• The Master-output can be connected via the RCA-sockets. Make sure that the sockets are set properly
(L & R).
• Via the BOOTH sockets, you can either connect active monitor-speakers for the DJ-booth or an additional
amplifier for creating a second zone.
• For recording, connect your tape recorder or cassette deck to the REC OUT-sockets. The REC OUT level
will not be influenced by the master-control. You can set the output level with the channel faders, the tone
controls and the GAIN control.
•The MIC 1 microphone can be connected via the XLR mounting-socket on the frontpanel. With the
Talkover-button, you can attenuate the level of all other signal-sources without affecting the microphone
volume. You can adjust the microphone volume using the CH-1 fader. Make sure that the
PHONO/LINE/MIC-switch is set to MIC.
Occupation unbalanced XLR-socket:
Unbalanced XLR mounting-socket:
1: Ground
2 1
2: In Phase (+)
3
3: Ground
16