Operation - Columbus Yale VS III Manual Del Equipo

24
When replacing the chain, make sure that the chain is reeved correctly. The chain weld must
face outwards.
250 - 1.500 kg 2.000 - 5.000 kg
Only fit load chains which have been approved by the manufacturer. Non-compliance with this
specification will render the legal warranty or guarantee void with immediate effect.
Inspection of the hand chain length
Adjust the length of the hand chain so that the distance of the lower end to the floor is between
500 – 1000 mm.
Function check
Before start-up, check that the chain drive is working in the unloaded condition.
O
PERATION
Installation, service, operation
Operators delegated to install, service or independently operate the hoist must have had
suitable training and be competent. Operators are to be specifically nominated by the
company and must be familiar with all relevant safety regulations of the country of use.
Repairs may only be carried out by authorized specialist workshops that use original
Yale spare parts.
Pulling the hand chain in clockwise direction will raise the load.
Attention: Depending on the type of load picked up, note that the lifting height may be
reduced for models with chain container!
Lowering the load
Pulling the hand chain in anticlockwise direction will lower the load.
Yale overload protection device (optional)
The overload protection device is set to approx. 25% (±15%) overload. Its adjustment must
only be carried out by a competent person.
When the load limit is exceeded, the overload protection device is activated and prevents
further lifting of the load, lowering is still possible.
©
2017 Columbus McKinnon Industrial Products GmbH