Installing And Removing The Maxi-Cosi Cabriofix When Used With Maxi-Cosi Easyfix Or Maxi-Cosi Easybase - Maxi-Cosi CabrioFix Manual Del Usuario

• Place the shoulder section of the seat belt around the Maxi-Cosi CabrioFix and slide it into the blue belt
12 13
hook on the back (12). The retaining hook holds the seat belt in place (13). Insert the tongue section into
14
the buckle (14,3).
• Make sure the seat belt is not twisted. Tighten it as much as possible.
• Check again to make sure the seat belt is threaded through all three blue belt hooks.
4.2 Installing and removing the Maxi-Cosi CabrioFix when used with the Maxi-Cosi EasyFix
GB or Maxi-Cosi EasyBase
The "click-and-go" installation on the Maxi-Cosi EasyFix and on the Maxi-Cosi EasyBase reduces the
likelihood of incorrect installation in the car.
The Maxi-Cosi EasyFix or Maxi-Cosi EasyBase should be installed first of all.
WARNING: To install or to remove the Maxi-Cosi EasyFix and Maxi-Cosi EasyBase see the instruction
manual of the Maxi-Cosi EasyFix and Maxi-Cosi EasyBase. The safety of your child is only guaranteed if the
seat is used correctly. It is therefore important that you take the time to read these instructions through
carefully. However, if you do not have the above mentioned instructions, contact our service point in your
country or download the necessary information from our internet site: www.maxi-cosi.com.
A. Installing the Maxi-Cosi CabrioFix
15 • Position the Maxi-Cosi CabrioFix facing backwards (rearward-facing) on the Maxi-Cosi EasyFix /
Maxi-Cosi EasyBase (15). The carrying handle should be in the upright position.
16 • Click the Maxi-Cosi CabrioFix with its 2 attachment rods onto the Maxi-Cosi EasyFix / Maxi-Cosi EasyBase (16).
17 • NOTE! A clear click should be audible and the indicators on the side of the base should now be completely
on green (17).
• NOTE! Under no circumstances should this product be used if the indicator remains on red. Carry out the
above actions again. In case of doubt or if you have any questions, contact the supplier.
• Check that the Maxi-Cosi CabrioFix has been installed correctly by pulling on it.
B. Removing the Maxi-Cosi CabrioFix
18 • Unlock the Maxi-Cosi CabrioFix by pulling the release lever upwards and at the same time forwards (18).
• The Maxi-Cosi CabrioFix can now be taken out of the Maxi-Cosi EasyFix / Maxi-Cosi EasyBase (19).
19
14
English